NOMA Alabaster Owner's Manual page 9

6. Attach Blade Assembly to Motor
· If there are plastic tabs shaped like bottle caps, remove
and discard them. These are stabilizers that protect the
motor during shipping.
· Remove blade bracket screws on the bottom
of the motor and use them to attach the blade
assembly to the motor. Ensure that the screws
are tightened (see Fig. 11).
7. Connect Switch Housing
· Remove the switch housing screws from the
switch housing cap and save for use in next step
(see Fig. 12).
· Connect the wire inside the switch housing cap by
snapping the male and female connectors together.
Match white wires together and blue wire to black
wire together (see Fig. 13).
8. Attach Light Kit
· Attach the Light Kit by bringing the switch housing
cap up to the fan switch housing .
· Then tightly secure the switch housing screws
that were previously removed from the switch
housing cap (see Fig. 14).
9. Attach Glass Shade
· Install two LED Bulbs (E12x7W)
included (see Fig. 15).
IMPORTANT NOTE: To be compliant with mandatory energy saving regulations,
your fan has a built-in wattage limiter. The limiter limits the wattage of the light kit
to 70 Watts. If you replace bulbs that exceed 70 Watts, then your light will not work.
To prevent this, ensure bulbs wattage is always less than 70 Watts.
9