Mark Levinson 5206 Owner's Manual page 27

Setup Menu
Input
Volume
Power
Display
Advanced
Config: This menu group allows you to lock, restore, import,
or export Setup configuration settings.
Config Export: Press Enter to export all setup configuration
information to a thumb drive inserted in the rear panel USB
port. This data can then be used to configure other N
units or serve as a backup so you can quickly reconfigure
your unit. Once you have your unit's configuration precisely
as you would like it, we strongly recommend you save a
Config Export file to a thumb drive in case an untoward
event erases your configuration settings.
Config Import: Press Enter to import all setup
configuration information from a thumb drive inserted in
the rear-panel USB port.
Config Lock: Engage the Lock to prevent accidentally
changing the Setup parameters. The factory default
setting is Off.
Config Restore: Restores all N
factory-default conditions.
Network: This menu offers access to the following network-
related parameters. They are useful only if you want to
connect your unit to a network to access controls and setup
functions via PC or tablet.
Name: Displays your N
format No5206XXXX (the X's represent the last four
characters of the unit's unique MAC address). Use the
input select control to select the character you want
to change, and the volume control to scroll through
available characters.
Current Gateway: Displays the Gateway IP address. This
setting is informational only and does not provide any
user adjustments.
Advanced
Firmware
Config
Network
Trigger
Front IR
5206 parameters to their
0
5206's network name in this
0
DHCP: Lets you toggle DHCP mode (network auto-
configuration) On or Off. The factory default behavior is
On. When the mode is set to Off, you can specify static IP
and Subnet addresses for your N
(available only when DHCP is set to On) refreshes your
DHCP configuration, assigning a new IP address to your
N 5206. This function is often useful when troubleshooting
0
a network connection.
Current IP: Shows the IP address currently assigned
at the factory (or by DHCP or manually) to your N
Enter this number in the address (URL) line of a browser
connected to the Internet. (This setting is informational
5206
0
only and does not provide any user adjustments.)
Current Subnet: Shows the subnet address currently
assigned (by DHCP or manually) to your N
setting is informational only and does not provide any
user adjustments.)
Trigger: This setting configures the 12V trigger. NOTE: Using
a trigger input overrides the Standby button.
Mode: These choices determine how the 12V trigger
signals are sent and received.
Normal: The default setting, appropriate for most
other components.
Pulsed: Some products (such as some older Mark
Levinson components) require a pulsed trigger signal.
Theater: Turns on the N
the input configured for SSP mode.
Off: Disables the Trigger In/Out connections.
Delay: This setting determines the amount of time after
fully exiting the Standby mode that the unit waits to pass
a trigger signal to the trigger output jack. The choices
are 0 - 10 seconds, with 0 being the default. NOTE: as it
can take a few seconds for the N
Standby mode, the net trigger delay time will be longer
than the value you select.
Front IR: This menu allows you to turn the N
receiver on or off. If you plan to use the rear-panel IR input,
you must set the front IR receiver to Off. If you use a 3rd party
control via IP or RS232, and do not plan to use IR for control,
we recommend you turn the IR control to Off.
5206. Selecting Renew
0
5805 and automatically selects
0
5206 to enter and exit
0
N 5206 PREAMPLIFIER / OWNER'S MANUAL
0
SETUP
5206.
0
5206. (This
0
5206's front IR
0
25