Brilix XHPFDPLUS60 User Manual page 16

- The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of installation.
- The cables must be properly installed to prevent interference. 5.Operation
- The pump is intended for connection to a general power supply with earth connection.
5.1 The functions of LED wire controller
- Section of the cable; This section is indicative and should be checked and adapted according to the needs
and conditions of use.
- The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of installation.
5.Operation
Up and down button
5.1 The functions of LED wire controller
Timer on button
5.2 How to know operation parameter
(1) Long press 5 seconds to enter operating parameter interface.
(2) Under parameter interface, Press
Up and down button
(3) Leave it 8 seconds, LED will display water in temperature (under running) or time (until stops)
(4) Under current mode, press
Timer on button
status.
(5) While running, the LED displays the water-in temperature and current mode
5.2 How to know operation parameter
(1) Long press 5 seconds to enter operating parameter interface.
(2) Under parameter interface, Press
(3) Leave it 8 seconds, LED will display water in temperature (under running) or time (until stops)
(4) Under current mode, press
status.
(5) While running, the LED displays the water-in temperature and current mode
Timer off button
(LED display show real time till HP unit is power off)
or to check the parameters
or to modify the water setting temperature whenever it is ON/OFF
Timer off button
(LED display show real time till HP unit is power off)
13
or to check the parameters
or to modify the water setting temperature whenever it is ON/OFF
13
15
LED display
Operation mode display
ON/OFF
LED display
Time button
Operation mode display
ON/OFF
Time button