Operation - Brilix XHPFDPLUS60 User Manual

220-240V ~ 50Hz
3-XPDLT0022S
Note: Electrical connection
5.4 Schéma zapojení bazénového tepelného čerpadla
The power supply for the heat pump must come, preferably, from an exclusive circuit with regulatory
XHP 200 Tri ,XHPFD200 Tri
protection components (30mA differential protection) and a magneto-thermal switch.
- The electrical installation must be carried out by a specialized professional (electrician) in accordance
with the standards and regulations in force in the country of installation.
- The heat pump circuit must be connected to a safety earth circuit at the terminal block.
- The cables must be properly installed to prevent interference.
- The pump is intended for connection to a general power supply with earth connection.
- Section of the cable; This section is indicative and should be checked and adapted according to the needs
and conditions of use.
- The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of installation.

5.Operation

5.1 The functions of LED wire controller
Up and down button
Timer on button
5.2 How to know operation parameter
(1) Long press
(2) Under parameter interface, Press
* The dotted line part are only used in some models
(3) Leave it 8 seconds, LED will display water in temperature (under running) or time (until stops)
(4) Under current mode, press
PE
SWITCH
(Water Pump)
* The dotted line part are only used in some models
ON
1 3 4 2
Current
checking
Timer off button
Current
checking
5 seconds to enter operating parameter interface.
or
or to modify the water setting temperature whenever it is ON/OFF
12
LED display
ON/OFF
Time button
(LED display show real time till HP unit is power off)
to check the parameters
13
14
3-XPDLT0052
Phase sequence protection
High voltage switch
Low voltage switch
Flow switch failure
Remote controller
Operation mode display