Network Setting - VTech VSP600 Administrator And Provisioning Manual

Network Setting

Use the Network setting menu to configure network-related settings for the base
station.
To use the Network setting menu:
1. From the Admin Settings menu, press  or  to highlight Network setting, and
then press MENU/SELECT.
The Network setting menu appears.
Network setting
DHCP
Set static IP
VLAN ID
Secure browsing
BACK ENTER
2. Press  or  to highlight the desired option, and then press MENU/SELECT:
 DHCP
 Set static IP
 VLAN ID
 Secure browsing
 Others (DNS and NTP servers).
To enable or disable DHCP:
1. From the Network setting menu, press  or  to highlight DHCP, and then press
MENU/SELECT.
2. Press MENU/SELECT to select Enabled or Disabled, and then press
DHCP is enabled by default, which means the deskset will get its IP address from the
network. When DHCP is disabled, you must enter a static IP address for the deskset.
NOTE: You must be familiar with TCP/IP principles and protocols to configure static
IP settings.
To set static IP for the base station:
1. From the Network setting menu, press  or  to highlight Set static IP, and
then press MENU/SELECT.
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an
error message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad to enter
characters. To add a period, press the * key.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
VSP600/VSP601 Administrator and Provisioning Manual
14
OK .
Using the Handset Menu