Starting Your Stove From An Empty Hopper; Trim Adjustment; Turning Your Stove Off - Pelpro PPC90 Manual

Using Your Stove

Starting your Stove from an empty hopper

5 Prime your Stove:
1) From "OFF" press
2) Press and hold until display reads "FEEDING."
The feed motor will run about 2 minutes.
6
Once feeding stops press power button.
CAUTION:
During this process DO NOT:
• Try to restart, manually add pellets or use any type of
accelerant
Comfort Settings
Control your comfort:
• POWER button - Used to turn your Stove on, off and to reset.
• Adjust temperature – Set to your desired temperature level. Once the desired temperature level is achieved the
Stove will automatically shut down. When the temperature in the room drops below the desired temperature level,
your Stove will automatically restart.
• LO setting – Your Stove will continue to run on low regardless of room temperature.
• HI setting - Your Stove will continue to run on high regardless of room temperature.
Pro Tip
If your Stove is turned to the off position and then back on, even if by mistake, your Stove
will go through the shutdown process (approximately 15 minutes) and restart.
Thermostat
Your PelPro Stove comes with a built-in thermostat system that provides easy temperature
adjustments. An external thermostat is available as an option (sold separately). To use an
external thermostat:
Install according to the manufacturer's instructions and connect to the back of your Stove.
1
Set THERMOSTAT to EXTERNAL in
2
Turn Stove on and set desired power setting.
3
16 PelPro Cast Pellet Stove • 7093-600J • 04/21
5
PRIME
DOWN BUTTON
6
START UP 11:59
ROOM:68 SET: HI
Pro Tip
For all menu items press after
making your selection to store
value.
HEATING @%
ROOM:68 SET: 72
settings menu on the digital display.
pelprostoves.com
Using Your Stove
If your Stove tries to start but fails on the initial burn, it will display MISSED IGNI-
TION.
1. Turn your Stove to off, remove and clean
the fire pot
2. Confirm fire pot is properly positioned
3. Ensure there are enough pellets in the hopper.
4. Prime your Stove per previous instructions

Trim Adjustment

Trim adjustment is located in the menu. This feature will adjust the
air/fuel ratio and below are examples of when to use it:
• If the fire is too large, lazy or producing black soot, adjust trim down one level at a time and allow 15 minutes
for stabilization before making another adjustment
• If your fire is too small and sometimes goes out when there are pellets in the hopper, adjust the trim up one level at
a time and allow 15 minutes for stabilization before making another adjustment.
WARNING!
This wood heater needs periodic inspection and repair for proper operation. It is against federal regulations to
operate this wood heater in a manner inconsistent with operating instructions in this manual.

Turning Your Stove Off

1 2
Press and hold power button for 3
seconds
CAUTION!
Smoke Hazard
Auger stops feeding pellets.
• Press power button on display to OFF,
let Stove completely cool and exhaust
blower must be off. Now you can unplug
Stove before servicing
• Smoke spillage into room can occur if
Stove is not cool before unplugging
pelprostoves.com PelPro Cast Pellet Stove • 7093-600J • 04/21
MISSED IGN
PWR TO RESET
TRIM
-2
3
Blowers continue to run until
after the exhaust temperature
has cooled.
17