Replacement Parts - Pelpro PPC90 Manual

Replacement Parts

Replacement Parts
Replacement part for your Stove
Visit pelprostoves.com
Zone 1 - Front of Stove
Glass
1. Open the door from the appliance by lifting door off of hinge pins
and lay on a flat surface face down.
2. Using a Phillips head screwdriver, remove the 3 brackets and
set aside.
3. Remove old glass and gasket from door.
4. Replace gasket to door and add glass.
5. Re-install the brackets using the same screws.
Glass replacement kit: SRV7081-173
Door assembly replacement kit: SRV7086-021
WARNING!
Glass is 5mm thick high temperature heat resistant ceramic glass.
• DO NOT REPLACE with any other material
• Alternate material may shatter and cause injury
Zone 2 - Firebox
Baffles
1. Turn the dial control to the off position. Make sure the appliance
is cool.
2. Remove the center baffle first by using the handle at the top of
the baffle and pull up and then towards you. The hooks on the
baffle will slide out of the slots in the bracket.
3. Remove the left baffle and then the right baffle by pulling up and
then towards you. The left and right baffles have similar hooks
and slots as the center baffle.
Replacement kit: SRV7079-006
22 PelPro Cast Pellet Stove • 7093-600J • 04/21
Zone Zone
1 1
Zone Zone
2 2
Zone Zone
3 3
Zone Zone
1 1
Zone Zone
2 2
Zone Zone
3 3
pelprostoves.com
Replacement Parts
Zone 3 - Back of Stove
Combustion Blower
1. Turn the dial control to the off position. Unplug the power to the
appliance.
2. The convection blower is located in the rear of the appliance.
3. Using a Phillips head screwdriver, loosen the bolts on the rear
of the appliance holding on the side panels. You do not need to
remove the screws. Removed side panels by lifting up and out.
4. Remove the two screws holding the convection blower housing
to the sheet metal plenum. Using a slight twisting motion, rotate
the blower back and it will release.
Replacement kit: KS-5020-1052
Exhaust Blower
1. Turn the dial control to the off position. Unplug the power to the appliance.
2. Remove the left side panel by loosening the three screws attaching it to the back of the appliance.
3. Disconnect 2 white wires from the white and blue wires of the exhaust blower.
4. Remove the blower motor attached to a removable plate to the exhaust blower. Depending on the model,
use a 1/4 inch socket, or 1/4 inch nut driver or Phillips head screwdriver to loosen the 6 screws in the keyhole
shaped holes and rotate the plate. It is only necessary to loosen screws.
5. Remove the exhaust blower and gasket.
6. Check for degradation on the gasket and replace if necessary using the gasket included in the kit.
7. Re-install in reverse order.
Replacement kit: 812-4400
pelprostoves.com PelPro Cast Pellet Stove • 7093-600J • 04/21
Zone Zone
1 1
Zone Zone
2 2
Zone Zone
3 3
23