Pelpro PPC90 Manual page 13

Replacement Parts
Snap Disc
1. Turn the dial control to the off position. Unplug the power to the
appliance.
2. Using Phillips head screwdriver, loosen the bolts on the rear of
the appliance holding on the left side panel (you do not need to
remove the screws). Remove side panels by lifting up and out.
3. Locate the snap disc on the top side of the feed tube where it
meets to the hopper. Disconnect the wire leads from the snap
disc.
4. Using a Phillips head screwdriver, remove two screws retaining
the snap disc on the side of the feed tube.
5. Using the same screws, attach the new snap disc; attach wire
leads.
6. Restore power.
Replacement kit: SRV230-0080
Igniter
1. Turn the dial control to the off position. Unplug the power to the appliance.
2. Unplug the wire leads to the igniter.
3. Remove the screw in the side of the igniter chamber. Pinch the ends of the bracket together and pull the ignit-
er straight out of the igniter chamber.
4. If there is difficulty in removing the igniter from the chamber, the chamber can be removed from the rear of the
firebox by removing the 1/4-20 bolts.
5. Re-install the new igniter into the chamber using the bracket.
6. Inspect the igniter from the front of the appliance by removing the firepot and looking into the end of the
chamber (MAKE SURE The IGNITER IS CENTERED IN THE CHAMBER).
Replacement kit: SRV7000-660
24 PelPro Cast Pellet Stove • 7093-600J • 04/21
Zone Zone
1 1
Zone Zone
2 2
Zone Zone
3 3
pelprostoves.com
Replacement Parts
Control Board
1. Turn the dial control to the off position. Unplug the power to the
appliance.
2. Unplug the wires from the control board. The connectors are
locking connectors. Pinch the release tab on each connector
and gently tug and rock loose.
3. Pinch the 4 plastic pins from the rear of the appliance to release
the control board connectors.
4. Install new board following the steps in reverse.
Replacement kit: SRV7093-050
Feed Motor Assembly
1. Turn the dial control to the off position and unplug the appliance. Remove the right side panel and feed motor
cover plate in the rear of the appliance.
2. Remove the 4 screws and cover plate.
3. Remove remaining pellets in feed assembly.
4. Unplug feed motor from wire harness.
5. Remove silicone from around busing end cap. Using Phillips head screwdriver remove 2 screws retaining the
end cap to the feed tube.
6. From inside the hopper, lightly tap on the end cap alternating side to side to remove feed assembly from feed
tube.
7. Re-install new feed assembly in reverse order; ensuring that the top of the feed bushing is in place and the
busing end cap is symmetrical in the feed tube chamber prior to final tightening of the retaining screws. Silicone
the end cap to the feed tube.
8. Plug the feed motor leads back in and restore power.
Replacement kit: SRV7077-014
pelprostoves.com PelPro Cast Pellet Stove • 7093-600J • 04/21
Zone Zone
1 1
Zone Zone
2 2
Zone Zone
3 3
25