Delta WASP 40100 Clay Manual Of Use And Maintenance page 4

INTRODUCTION
Delta WASP Clay line features all the latest technological innovations in the world of digital ceramics developed
by WASP.
The Manufacturer declines any responsibility for accidental damages caused by products when non-correctly
used.
WASP certifies the use LDM WASP Extruder and LDM WASP Extruder XL with ceramic materials, in case of use
of the system with different kind of materials, warranty and support may not be valid anymore.
WARNING
-Read accurately the instructions before the use
-Before any intervention in proximity or inside the work area pause the movements by pushing the yellow
bottom on the right side of the frontal panel
-Make sure, before everything is in pressure, that the two caps are both tighten completely until the complete
coverage of the tank fillet
-Check periodically that the fillet of the caps and of the tank are not consumed or damaged
-Always keep the fillet on the caps clean in order to avoid the uncorrect closure of the tank
-Periodically put some grease on the fillet of the caps and tank
-Check out the video tutorials at https://www.youtube.com/watch?v=1DjVC5MxJr4
-Do not introduce or lay hands or other parts of the body in proximity of the moving parts
-Keep far from the presence of children
-Do not overcome the 8 bars of pressure
-Do not point the pressurized tank without the cap against people
-Make sure that all the pipes are correctly plugged
-Check the if the fan on the left of the stepper motor is working or not
-Make sure that the extruder is not clogged
-Do not put fingers inside the extruder
-Do not eat the extruded materials
-Make sure that the pipes do not present any deformation
-Verify the waste of the pipes in the points of connection
-Do not replace parts if not original and supplied by Manufacturer
-Only properly formed staff can use the machine
© CSP S.r.l.
4
4