Table of Contents
Advertisement
3.2. Unpackaging
ENVIRONMENTAL NOTE:
Once the packaging has been removed from the printer it is recommended to keep it for any
requests for assistance from the Manufacturer.
The printer will be delivered in a horizontally oriented wooden box.
After removing the printer from the case, you must place the printer upright.
NOTE:
To perform this procedure it is required the presence of three operators because two will take care
of overturning it and the other will keep it steady on one side.
3.3. Content
The printer is supplied with:
•
"Getting started" guide
•
SD card
•
Power cable
•
Pipes
•
Tank
•
Tank support with spring
•
Material 10 kgs
3.4. Lifting and handling of the printer
ATTENTION:
The weight of the printer is shown in paragraph 2.4 "Technical data". It is therefore necessary to use
the lifting equipment whose expected flow is adequate for the weight to be lifted.
ATTENTION:
As long as the printer is not completely raised, it is advisable to check the correct balance of the
same. During lifting, all the area around the printer is considered dangerous.
ATTENTION:
All small equipment that exceeds the weight of 25 kg must be transported with the appropriate
equipment, or manually (if not exceeding 50Kg) by two qualified operators.
© CSP S.r.l.
© CSP S.r.l.
Transport and handling
21
3
21
Advertisement
Table of Contents
