First Start - Delta WASP 40100 Clay Manual Of Use And Maintenance

5
Preparing to use the printer

5.4. First start

After having correctly connected the printer to the socket it is necessary to perform some operations in order to
allow the printer to work.
Belt-stop clamps
Inside the printer there are three belts necessary for moving the extruder during printing.
To avoid movements of the extruder during transport, clamps are applied on the straps, to be removed before
starting the printer.
ATTENTION:
Pay attenention in all the phases and watch your head
To perform the first print, proceed as described here:
1. Place the tank support aligned with the two holes on the top of the printer
2. Tighten the 2 screwsfor blocking the tank support
3. Turn on the printer with the ON/OFF button on the back column of the printer
4. Using the control handle select Menu>Prepare>Load material
5. Wait for the extruder to move at middle-height position
6. Grab the loaded tank and insert it in the support
7. Plug the nylon pipe for the air in the proper connector
8. Put the tank to pressure rotating the pressure controller on the left side of the printer
9. Extrude some material Menu>Extrude material
10. Zero the machine Menu>Prepare>Autohome
11. Mesaure the distance with modify height Menu>Prepare>Modify height (adviced 0.5 mm between nozzle and
bed)
12. Perform manual levelling adjusting the 3 screws until the best planarity is reached
13. Launch the print from Menu>SD card> file.gcode
28
28
© CSP S.r.l. © CSP S.r.l.