Bauer 20181F-B Owner's Manual & Safety Instructions page 8

adding Staples
tO prEVEnt SEriOuS inJury FrOM acciDEntaL DiScHarGE, BEFOrE LOaDinG:
• Wear anSi-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
• turn power Switch off.
• attempt to discharge the tool into a piece of scrap wood to ensure that
it is disconnected and is incapable of driving any fasteners.
1. Turn the Stapler upside down. Pull
the Magazine Lock down and pull the
Pusher out as far as it will go.
General Operating instructions
1. Turn the power switch on.
2. Before each use, test the tool as
directed in the prior section.
WarninG! tO prEVEnt
SEriOuS inJury: Keep second hand
away from tool discharge area,
especially if holding workpiece.
tool applies extreme force to fastener,
and fasteners may deflect or discharge in an
unexpected direction.
cautiOn! tO prEVEnt inJury:
Do not hold tool near body while driving.
tool recoil can cause injury.
Page 8
Magazine Lock
For technical questions, please call 1-888-866-5797.
2. Insert staples into the Magazine so that
the pointed ends are facing up.
compartment
3. Slide the Pusher in until the Magazine
Lock snaps securely in place.
3. Position tool at desired fastener location
and depress the Contact Safety fully
against the workpiece. Squeeze the
Trigger to discharge a fastener.
note: Depress the Contact Safety before
each squeeze of the Trigger.
4. after use, to prevent accidents:
a. turn the power switch off.
b. attempt to discharge the tool into a piece of
scrap wood to ensure that it is disconnected
and is incapable of driving any fasteners.
c. release the trigger again.
d. clean external surfaces with clean, dry cloth.
e. Store indoors out of children's reach.
Loading
Item 57241