FujiFilm Fujinon UA14X4.5BERD-S6B Operation Manual page 61

①
②
⑤
③
④
The illustration shows the positions set at the factory.
① Camera Communication ON/OFF Switch
②
Analog Zoom Demand Zoom Mode Function ON/OFF Switch
③
④ Robotic, P/T Mode Select Switch
⑤ Zoom Mode Select Switch
① Camera Communication ON/OFF switch
Ths swtch changes the functon of seral
communcaton wth a camera to ON and
OFF.
Note. Set this switch to "OFF" when a
malfunction occurs and it is assumed
that the malfunction is caused by a
serial communication failure.
②③ Analog Zoom Demand Zoom Mode Function
ON/OFF Switch
In a zoom operaton wth an analog zoom
demand control unt, the zoom mode functon
(functon of selectng the characterstcs of
"zoom speed vs zoom control sgnal" ) can be
swtched to ON and OFF.
④ Robotic, P/T Mode Select Switch
To control the lens va seral communcaton
by mountng the camera to the Robot
System or the pan-tlt head, turn ths
swtch ON.
⑤ Zoom Mode select switch
The characterstcs of "Zoom Speed
vs Rotatonal Angle of Zoom Seesaw
Control Lever" can be selected from
ten modes.
Refer to the followng figure.
FUNCTION & MODE SELECT SWITCHES
SW1
Settings of Function
& Mode Select
Switches (SW2)
SW2- ② SW2- ③
ON
ON
OFF
OFF
W
Rotational Angle of zoom seesaw control lever
- E- -
SW2
Rubber Cap
Zoom Mode Function
ON Enable （ON）
OFF Disable （OFF）
ON Enable （ON）
Disable （OFF）
・ To operate the zoom with the lens
mounted on a pan-tilt head, use
these settings.
・ When the camera is powered ON
OFF
with these settings while the zoom
servo/manual select knob is being
set to "S," initial zoom operation
is performed immediately after
power ON.
MAX.
0
No.9
No.4
(Normal)
No.0
T