Advertisement
20. Slide the spiral retaining ring down and thread it into the
retaining ring groove of the nut in the same manner as you did in
step 12 for the front nut.
21. Turn the rear nut counter clock wise until you can feel resistance.
Do not force the nut any further than the point you feel resistance
or it will force the seal and retainer out of place.
22. Turn the nut back until the front and rear nut are in line with
each other. This sets the timing of the front and rear nut.
23. Slide the nut and screw assembly back into the vise until it reaches
the holding block assembly.
24. Make sure that the set screw in the holding block is facing up.
Place the rubber spring pre-load block (#34) and steel wedge friction
clamp (#33) into the space on the right side of the holding block
(#17). If these parts show excessive ware, or are deformed you may
want to replace them.
25. Place the stationary jaw back on your vise and tighten
26.Place the rear moveable on your vise and snap into place
Place the handle on the hex of the screw and turn clockwise
27.
until the rear moveable closes tight against the stationary
jaw. Continue to tighten your vise until it draws the holding block
containing the friction clamp into the vise. You will feel some
resistance until the friction block slides into the vise. If the friction
clamp will not slide into the vise, it may be necessary to use a
hammer and punch to lightly tap on the friction clamp while
maintaining pressure on the screw.
Once the holding block has slid into the vise body you can place
28.
your front moveable jaw on the vise and snap into place.
Advertisement
