Advertisement
Disassembling the holding block
1. Remove set screw (#25) and set aside
2. Using a spanner wrench turn the threaded collar (#23) counter
clockwise and remove it from the holding block.
3. Turn the holding block upside down and gently tap it until remaining
items slide out of holding block. Remaining items will be the thrust
washers (#19) 3 each, thrust bearing (#20) 1 each, collar (#22) 1 each,
spring (#21) 6 each.
Reassembly of the holding block
1. Place a new o-ring (#18) in the holding block (#17)
2. Place a new o-ring (#24) in the threaded collar (#23)
3. Place holding block (#17) on a flat surface with the threaded end up.
4. Place the following parts in the holding block in the order listed
a. Thrust bearing washer (#19)
b. Thrust bearing (#20) Coat with a high grade grease
c. Thrust bearing washer (#19)
d. Collar (#22)
e. Six compression springs (#21) Placed in the holes of the collar
f. Thrust bearing washer (#19)
Advertisement
