Manual Operation - HYDAC FILTER SYSTEMS MFU-15E Operating And Maintenance Instructions Manual

HYDAC FILTER SYSTEMS GMBH
BeWa MFU-15E_S 4391552c en-us web

6 Manual operation

Select the required operating mode as described in Chapter
Selecting the operating modes [} 73]. Connect the suction
port/pressure port to the containers or systems to be cleaned
and switch the filter unit on at the main switch and switch the
compressed air supply on.
To monitor the service life of the filter element , the filter unit is
equipped with a clogging indicator (optical back pressure indi-
cator).
Check this daily through a visual check during operation. See
Chapter Observe the optical clogging indicator [} 72].
When the clogging indicator has responded or the pointer is in
the red zone, exchange the filter element.
If the container to be filled is full or if the required oil cleanli-
ness has been achieved, switch off the filter unit at the main
switch. Empty the contents of the suction and pressure hoses
into the respective containers and secure the cable and hoses
as described in Chapter Transportation / Storage [} 47].
Manual operation | 6
1
2
3
4
5
6
7
8
9
A
71 / 120