Continuous Drainage; Protections And Error Codes - INVENTOR SMR-25L User Manual

• Do not turn off the device when defrost mode is on.
•The dehumidifier will require more defrost operations when the room temperature is
low.
For better results operate the dehumidifier in rooms with temperature not lower than
16°C

5.4 Continuous drainage

Water automatically can be emptied into a floor drain by attaching the unit with a water
hose. Remove the rubber plug from the back of the unit. Insert the water hose into the
drain outlet and make sure all connections are firmly tightened in order to avoid any
possible leaks.
The dehumidifier should be placed on a flat surface in an upright position.
Lead the water hose towards a suitable drainage facility and be certain that the water flows
naturally. For correct drainage, make sure the hose stays below the level of the drain hose
outlet.

5.5 Protections and Error codes

Protections:
Compressor's 5 minutes delay Protection: In order to extend the compressor΄s lifetime
there is a 5 minutes delay after the compressor's last operation for the compressor to start
operating again.
High and Low temperature protection
When the sensor detects the ambient temperature lower than 3ºC or higher than 40ºC the
compressor will stop operating and the fan motor will keep working.
When the ambient temperature will reach within the operating range (lower than 38ºC or
higher than 5ºC) the device will resume the operations normally.
LO: Ambient humidity lower than 30%RH
When Low humidity is detected the compressor will stop and the fan will keep operating in
the selected settings. Once room humidity ≥32%RH detected, the compressor will resume
its operation in the previous settings.
HI: Ambient humidity higher than 80%RH
During this condition, the compressor will keep operating in the selected
settings. Once room humidity drops under ≤80%RH the protection code HI will disappear.
High ambient temperature and fan speed
When high ambient temperature is detected the fan speed will automatically set on high
speed.
EN
11