Camera Set Installation - Lanberg 4–CHANNEL ICS–0404–0020 User Manual

E. CAMERA SET INSTALLATION
Power
1. Place the recorder at the target location.
NOTE: IT IS NOT RECOMMENDED TO PLACE THE RECORDER IN A BUILT–UP AREA, IT MAY NEGATIVELY
AFFECT THE WIFI SIGNAL RANGE.
2. Screw the antennas to the recorder and to the cameras.
3. Then connect the monitor to the recorder using a VGA or HDMI cable (not supplied).
4. Connect the recorder to power using the dedicated power supply (12V 2A). When power is applied, the device
will start booting up.
5. Connect the cameras to power using the dedicated power supply (12V 1A). After about 5 minutes, the cameras
should synchronize with the recorder and their images should appear on the screen.
6. Connect a mouse (not included) to the USB port.
7. Follow the on–screen instructions, the setup wizard will guide you through the initial system configuration.
For a detailed description of the wizard, see Section F.
8. The menu of the recorder is opened with a right mouse button. The first time you open it, you will be asked
for a login and password. Default values:
Login: admin
Password: none (leave this field blank)
9. The recorder is ready for operation.
NOTE: WHEN YOU LOG IN FOR THE FIRST TIME, WE RECOMMEND CHANGING YOUR DEFAULT LOGIN
DETAILS. PASSWORD SETTINGS CAN BE FOUND IN THE SYSTEM SETTINGS, SEE SECTION H.5.C.
EN
Cameras
SUB
Recorder (NVR)
Router
Lanberg © 2015-2021
Monitor / TV
HDMI / VGA
HDMI USB USB
AUDIO OUT VGA
RJ45 Cable
Power
MAIN
DC 12V
USB Mouse
7