Alvarion BreezeACCESS SU-M-900 Installation Manual page 23

Installation
To connect the SU-M-900 Unit:
1.
Once the SU-M-900 unit is installed in the vehicle, connect the 12 VDC
power cable to the unit's DC IN port.
2.
Wire the other end of the cable to the power source, ensuring that the
cable is secure and out-of-the-way for its protection. Proper polarity
must be observed, with the black cable attached to negative and the
red to positive.
3.
Use a straight Ethernet 10Base-T cable to connect a PC to the Ethernet
ETH port located on the front panel of the unit. Use a crossed cable to
connect to a hub/switch (the unit can support up to 8 devices). Ensure
that the cable is secure and out-of-the-way for its protection.
4.
Connect the antenna cable to the ANT port on the SU-M-900. Ensure
that the cable is secure and out-of-the-way to protect it from snagging
or breaking.
NOTE:
The SU-M-900's case may only be opened by an authorized technician. Should anyone
other than an authorized technician open the case, the warranty may be voided.
2-7