Accessing Playback - GeoVision GV-Edge Quick Start Manual

9. Accessing Playback

You can remotely play back host recordings on GV-Edge Recording Manager. Follow the
steps below to playback:
Note:
1. For a GV-DVR / NVR / VMS host, make sure Remote Viewlog Service (under Control
Center Service) is enabled ahead to allow GV-Edge Recording Manager to remotely
access the host for playback.
2. Audio playback is not supported by the Mac version of GV-Edge Recording Manager.
1. Click the Playback button
2. Select a device from the left. A calendar appears below.
3. Click to select a date for playback. Recordings of the selected date are listed (if any).

On AVI Player: The current date is highlighted yellow and the selected date blue.

On MPEG4 Player: The current date is highlighted blue, the selected date blue and dates with
recordings are circled red.
4. Click an entry and click
[AVI Player] Click an entry to play back.
3
4
on the main window. The Playback page appears.
. The recording is immediately played back.
2
33
1