WEG CFW100-IODR Installation, Configuration And Operations Manual page 7

NOTE!
The firmware version of the CFW100-IODR
can be viewed in parameter P024 of the
CFW100 inverter.
ATTENTION!
For the proper operation of the CFW100
inverter with the CFW100-IODR module,
parameters P308, P310, P311 and P312 must
be programmed with the factory settings.
For further details, refer to the programming
manual of the CFW100 V2.0X or up.
Information about parameter configuration of the CFW100
inverter related to the CFW100-IODR accessory is
provided in Table 2 on page
Table 2: List of parameters related to the CFW100-IODR
Param. Description
P012 DI3 to DI1
Status
P013 DO3
to DO1
(*)
Status
P027 Accessory
Config.
Encoder
P038
Speed
(*)
Number
P039
of Pulses
(*)
of the
Encoder
I/O Expansion Module and
Incremental Encoder Input
7.
accessory
Adjustable
Range
0 to 7 (hexa)
Bit 0 = DI1
Bit 1 = DI2
Bit 2 = DI3
0 to 7 (hexa)
Bit 0 = DO1
Bit 1 = DO2
Bit 2 = DO3
0 = Without Accessory
1 = Reserved
2 = CFW100-IOAR
3 = CFW100-CCAN
4 = CFW100-CBLT
5 = CFW100-IODR
6 = Reserved
-9999 to 9999 rpm
-32767 to 32767
Factory
Prop.
Setting
ro
ro
ro
ro
ro
CFW100 | 7