Setting The Cutting Depth; Setting The Cutting Angle (Mitre Angle); Note The Cut Line; Connecting The Guide Rails - Parkside PTSS 1200 C2 Original Instructions Manual

Setting the cutting depth

♦ Undo the screw for the cutting depth
adjustment and push the stop to the desired
cutting depth on the cutting depth scale
–
without guide rail, see mark A.
–
with guide rail, see mark B.
♦ Retighten the screw for the cutting depth
adjustment .
NOTE
► Adjust the cutting depth to the thickness of the
workpiece. The blade should not extend more
than one full tooth depth under the workpiece.
Setting the cutting angle
(mitre angle)
♦ Undo the two adjustment wheels for the cutting
angle .
♦ Tilt the motor to the desired cutting angle.
♦ Retighten the adjustment wheels
NOTE
► If you have set the cutting angle adjustment to
0° or 45°, you can use the fine adjustment
8a
screws and
ment that you require.

Note the cut line

9a
♦ Cut line markings
into the base plate
♦ Align the appliance to the corresponding 0° or
45° cut line markings
the set cutting angle.
♦ The inclined surfaces are reference points for this.
PTSS 1200 C2
.
to make any fine adjust-
of 0°/45° are imprinted
.
9a
in accordance with
9a

Connecting the guide rails

The guide rails
cuts.
:
♦ To connect the 2 guide rails, push the
connector
Tighten the grub screws
hex key.
NOTE
► The guide rails
(black rubber lip). The splinter guard must be
adjusted before making the first cut. Place the
guide rail onto a workpiece. Set a cutting
depth of approx. 10 mm. Switch the circular
saw on and push it gently and evenly in the
cutting direction.
will help you to make straight
into the groove of the guide rails.
using the supplied
have a splinter guard
GB │ IE │
9 ■