Operation; Switching On And Off; Setting The Cutting Depth (Dive Depth); Setting The Cutting Angle (Mitre Angle) - Parkside PTSS 1200 A1 Translation Of The Original Instructions

Operation

Switching on and off
Switching on:
♦ Push the safety lock-out
GB
in position.
♦ Press the ON/OFF switch
running, you can release the safety lock-out
Switching off:
♦ Release the ON/OFF switch

Setting the cutting depth (dive depth)

♦ Undo the screw for the cutting depth adjust-
ment and push the stop to the desired
cutting depth on the cutting depth scale
–
without guide rail, see mark A.
–
with guide rail, see mark B.
♦ Retighten the screw for the cutting depth adjust-
ment .
NOTE
► Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth height
should be visible below the workpiece.
Setting the cutting angle
(mitre angle)
♦ Loosen the two adjustment wheels for the
cutting angle
♦ Tilt the motor to the desired cutting angle.
♦ Retighten the adjustment wheels
NOTE
► If you have set the cutting angle adjustment to
0° or 45°, you can use the fine adjustment
screws and
ment that you require.
20
upwards and hold it
. Once the saw is
.
.
.
to make any fine adjust-
8a

Note the cut line

♦ Cut line markings
into the base plate
♦ Align the appliance to the corresponding 0°
or 45° cut line markings
with the set cutting angle.
♦ The inclined surfaces are reference points for
.
this.
:

Connecting the guide rails

The guide rails
cuts.
♦ To connect the 2 guide rails, push the connec-
tor into the groove of the guide rails. Tighten
the grub screws
NOTE
► The guide rails
(black rubber lip). The splinter guard must be
adjusted before making the first cut. Place the
guide rail onto a workpiece. Set a cutting
depth of approx. 10 mm. Switch the circular
saw on and push it gently and evenly in the
cutting direction.
of 0°/45° are imprinted
9a
.
in accordance
9a
will help you to make straight
using the Hex key supplied.
have a splinter guard
PTSS 1200 A1
9a