HP StoreOnce G3 Installation And Configuration Manual page 21

192.168.1.27
Enter subnet mask :
255.255.255.0
Do you want to configure a static default gateway for this subnet or get gateway from DHCP?
1.) Gateway obtained from DHCP server (default)
2.) Set gateway manually
2
Enter gateway IP address :
192.168.1.1
Do you want to configure the network domain name or get domain name from DHCP?
1.) Domain name obtained from DHCP server (default)
2.) Set domain name manually (e.g. mydomain.local)
2
Enter domain name :
mydomain.local
----------------------
Network: Subnet_1
----------------------
IP Address: 192.168.1.27
Net Mask: 255.255.255.0
Domain Name: mydomain.local
Gateway: 192.168.1.1
Bonding Mode: 6 (Active Load Balance Bonding)
Interfaces:eth0 eth1
Is this configuration correct?
1.) Yes (default)
2.) No
1
Do you want to configure another subnet?
1.) No (default)
2.) Yes
1
Select a default network (The default network shall be used as the default gateway subnet)
1.) Subnet_1 (default)
1
Step Complete. Do you want to :
1.) Go to next step: Step 3.) (default)
2.) Go back to previous step: Step 1.)
3.) Go back to start of present step: Step 2.)
4.) Quit wizard and lose all settings
1
Step 3.)
----------------------
Network Name: Network_Config_by_Wizard
Network Description: Network configuration created by network config wizard on: 14:17:9 3 October 2012
Write Protected: no
DNS Servers:1.1.1.1
----------------------
Number of Networks:1
----------------------
Network: Subnet_1 (default)
----------------------
IP Address: 2.2.2.2
Net Mask: 255.0.0.0
Domain Name: kev.net
Gateway: 3.3.3.3
Bonding Mode: 6 (Active Load Balance Bonding)
Interfaces:eth0 eth2
Press any key to continue
Step Complete. Do you want to :
1.) Finish wizard and apply settings (default)
2.) Go back to previous step: Step 2.)
3.) Go back to start of present step: Step 3.)
4.) Quit wizard and lose all settings
1
You have successfully configured the network settings
on your StoreOnce Appliance.
The network configuration wizard 21