Table of Contents
Advertisement
3.
Follow the instructions provided in the wizard text. Prompts appear in the following sequence.
Step 1: DNS addresses (optional)
Step 2: Subnet configuration. The prompts displayed in this section will vary depending
upon the responses you make to the prompts for your network configuration. It is at the
end of this step that you are given the opportunity of configuring a second subnet.
Step 3: Network configuration summary. The final step provides network configuration
details. If you are satisfied that the network is configured correctly, key 1 to finish the
wizard and apply the settings.
4.
Your network is now configured and you can access the HP StoreOnce Backup system remotely
via the StoreOnce GUI or CLI. Be sure to save a copy of the configuration, as described in
the HP StoreOnce Backup system user guide. If you need to make subsequent changes to the
network configuration, use the StoreOnce CLI, as described in the HP StoreOnce CLI Reference
Guide.
Example wizard sequence
The following example shows the prompts and answers to configure an Active Load Balance
bonded network connection (Mode 6) on the 1GbE ports to a subnet that uses static IP addressing.
# net set wizard
StoreOnce Network Configuration Wizard
--------------------------------------
This Wizard will guide you through the configuration of
network settings on your StoreOnce Backup System
If you wish to make additions or modifications to an existing
network configuration without having to reconfigure all settings
then use the 'net modify' or 'net add' CLI commands instead
The wizard consists of the following steps:
Step 1.) Set system wide DNS server addresses (Optional)
Step 2.) Configure network settings for available network adapters
Step 3.) Save and apply all network settings
Type 'quit' + ENTER at any time to exit wizard
Step 1.)Set system wide DNS server addresses (optional)
Enter a list (max 3) of DNS servers separated by commas : (eg 192.168.1.100,192.168.3.100)
192.168.1.100,192.168.3.100
Step Complete. Do you want to :
1.) Go to next step: Step 2.) (default)
2.) Go back to start of present step: Step 1.)
3.) Quit wizard and lose all settings
1
Step 2.)Configure network settings for available network adapters
Select the type of configuration for this subnet :
1.) Single port (default)
2.) Bonded ports (note ports must be the same speed to bond
-->2
<--Bonded/Single: Bonded ports (note ports must be the same speed to bond)
Select bond configuration :
1 = eth0 and eth1 (1 Gig) (default)
2 = eth4 and eth5 (10 Gig)
-->1
<--Bonding: eth0 and eth1 (1 Gig)
Select the desired bonding mode :
1 = Mode 1 - Active Passive Bonding (default)
2 = Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
3 = Mode 6 - Active Load Balance Bonding
-->3
Select Static or DHCP addressing :
1.) DHCP (default)
2.) Static
2
Enter static IP address :
20
Network configuration
Hide quick links:
Advertisement
Table of Contents
