Powering On And Managing The Storeonce Management System; Powering On The Hp Storeonce Backup System; Dicovering The Hp Storeonce Backup System On The Network - HP StoreOnce G3 Installation And Configuration Manual

3 Powering on and managing the StoreOnce Management
system
In this chapter:
Powering on the HP StoreOnce Backup system (page 14)
Discovering the HP StoreOnce Backup system on the network (page 14)
Accessing the StoreOnce Management console (page 15)
User accounts (page 16)

Powering on the HP StoreOnce Backup system

NOTE: Ensure that any expansion shelves attached to the system are powered on before pressing
the Power button. You may need to hold down the power on button (on the rear of each unit) for
a few seconds.
Press the Power on button on the front of your HP StoreOnce Backup system. The normal boot
sequence takes approximately 2 minutes (5 minutes for the HP StoreOnce 4430/4420 Backup
system). On power up the HP StoreOnce Backup system runs its fans at high speed for approximately
10 seconds before returning to normal speed.
Figure 7 Powering on the HP StoreOnce 4430/20 Backup system
Figure 8 Powering on the HP StoreOnce 4220/4210 Backup system
Figure 9 Powering on the HP StoreOnce 2620 Series Backup system
1. Power On button

Dicovering the HP StoreOnce Backup system on the network

If you have used the Quick Install option of connecting LAN Port 1 to a DHCP-enabled 1GbE
network, you will be able to manage the StoreOnce Management Console from any client attached
14

Powering on and managing the StoreOnce Management system