Samsung XA067T User Manual page 73

Step 1 Click
click .
Step 2 If you have not finished configuration of light sensor, it is need to configure the
light sensor then, the detailed operation, please refer to the
Adjustment.
Step 3 Add specified brightness, ambient brightness as required, or edit or delete the
added settings.
All operations are finished, click
Auto Brightness Time Interval
The following steps are to set the time interval for auto brightness.
Step 1 Click right button on the circled panel icon, as shown below
Step 2 Select Brightness Advanced Settings to open the advanced settings window.
Step 3 Set the values for Detect Period and Read times of light sensors. Detect
Period is the time period the light sensors measure the environment brightness. Read
times of light sensors is the times that NovaLCT reads the measurement results of the
light sensors. Thus the auto brightness time interval is the production of Detect Period and
Read times of light sensors.
For example, if light sensors measure the environment brightness every 10 second (this is
the Detect Period.) and NovaLCT reads the measurement results of the light sensors for 5
times (this is the Read times of light sensor.) before adjusting the LED display brightness,
the auto brightness time interval will be 50 seconds.
Note:
The default values for Detect Period and Read times of light sensors are 60
seconds and 5 times respectively. Thus the auto brightness time interval is
300 seconds or 5 minutes by default.
, check Adjust by Light Sensor, then
.
step 3) in Advanced
73