Samsung XA067T User Manual page 72

l When light sensor fails, adjust the brightness to: Enabled after being checked. If
not enabled, when light sensor fails, the brightness will remain at the latest updated
brightness value.
l : Divide the portion between the maximum environment brightness and
minimum environment brightness into designated equal parts, the portion between the
maximum and minimum LED display brightness is also divided into similar equal parts.
The software will adjust the LED display brightness to corresponding section in
accordance with the section of current environment brightness.
Note:
NovaLCT first generates the environment brightness value from
measurement results of all available light sensors according to the
calculating type. And then NovaLCT uses the generated environment
brightness to adjust the LED display brightness according to the
parameter settings, such as brightness thresholds, segment numbers.
l Night Mode
Night mode is to control screen brightness at night. The night mode is required to be
enabled to avoid abnormal screen brightness caused by light sensor that disturbed by
external light or by abnormal collection environment brightness data.
In night mode, the system will adjust the screen brightness to the maximum brightness
value in night mode while the screen brightness which is adjusted based on the
environment data collected through the light sensor is greater than the set maximum
brightness value in night mode.
1. Select the check box in front of Opening to start the night mode.
2. Click to add setting items of the night mode including Start time, End time and
Brightness maximum.
−
Start time: Set the start time for the night mode.
−
End time: Set the end time for the night mode.
−
Brightness maximum: Set the maximum brightness value in night mode.
Note:
3. Click OK to complete the night mode setting.
Click Finish to complete the light sensor setting.
Adjust by Light Sensor
One time point will be generated by NovaLCT automatically, and it will be configured with
environment brightness by default.
l Maximum of 4 periods could be set for the night mode, and
there cannot be any overlap between every two periods.
l When the night mode is enabled, at least one period must be
set.
l When the start time and end time are set to the same time
value, night mode is default as the only serving mode all the
time.
l The system does not support hardware-based adjustment.
l A selected record could be modified by clicking the icon.
72