ADJ STARTEC BOOM BOX FX2 User Manual page 15

Boom Box FX2
DNST - This mode can be used as a precaution mode, in case the DMX signal is lost, inter-
rupted, or power is lost, the operating mode chosen in the setup is the running mode the fix-
ture will go into when the DMX signal is lost. You can also set this as the operating mode you
would like the unit to return to when power is applied.
1. Press the MENU button until "DNST" is displayed, and either "PRSE", "BLND", or "LAST" will be
displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choose
an operating mode you would like the unit to start up in when power is applied or the DMX signal
is lost.
- LAST - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is
applied and this mode is set, the unit will automatically go into the last DMX set up.
- PRSE (Primary/Secondary) - If the DMX signal is lost or power is applied, the unit will
automatically go into Primary/Secondary mode and run a built-in show.
- BLAC (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
3. Press ENTER to confirm your desired set up.
DISP - This function will reverse the display 180º.
1. Press the MENU button until "DISP" is displayed, press ENTER.
2. Press ENTER to "flip" the display.
Press ENTER to "flip" it again. Press ENTER when you have made your desired setup.
LED - With this function you can have the LED display turn off after 10 seconds.
1. Press the MENU button until "LED" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to
keep the LED display on at all times, or "OFF" to switch to have the LED display switch off after
10 seconds.
TEST - This function will run a self test program.
1. Press the MENU button until "TEST" is displayed, press ENTER.
2. The fixture will now run a self test.
FHRS - With this function you can display the running time of the unit.
1. Press the MENU button until "FHRS" is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU to exit.
VER - Use this function to display the Software version of the unit.
1. Press the either the MENU button until "VER" is displayed, press ENTER.
2. The display will show the software version.
RSET - This function will reset the unit.
1. Press the MENU button until "RSET" is displayed. Press the ENTER button and the unit will reset
itself.
ADJ Products, LLC - www.adj.com - Boom Box FX2 User Manual Page 15
System Menu