Advertisement
1.
B
2-Way Junction
U
Half Stabiliser Foot
see SASS-0082
for assembly
For assembling the half stabiliser foot (U) please follow SASS-0082 instructions and
attach to the 850w side panel (A).
Insert the modular screws in the 850w side panel (A) into the keyholes in the 2-way
junction (B), making sure that all of the screws have engaged into the keyholes.
3.
Insert the modular screws in the 650w back panel (C) into the keyholes in the 2-way
junction (B), making sure that all of the screws have engaged into the keyholes. (see
step 1 for method).
DEN.Curve Assembly Instructions
A
850w Side Panel
C
650w Back Panel
2.
Z
Bottom Connector Link
Junction
After making sure all of the screws are engaged in the keyholes, tap the top of the
850w side panel (A) with a cushioned mallet to fully engage.Tie the 850w side panel
(A) to the 2-way junction (B) using a bottom connector link (Z). Insert this over one of
the levellers (between the nut and the bottom of the panel/junction) in the hooked slot
and pivot around to insert the other leveller into the straight slot. Fully tighten both
nuts using a 13mm spanner to trap the connector (Z).
4.
Z
Bottom Connector Link
Tap the top of the 650w back panel (C) with a cushioned mallet to fully engage.
Tie the 650w back panel (C) to the 2-way junction (B) using a bottom connector link
(Z). (see step 2 for method).
Panel
Connector
M8 nut
Leveller
DWG No: SASS-0065
Revision: A (27/10/15)
Drawn by: JB
Drawn date: 13/07/15
Advertisement
