Advertisement
4. Connect the scale.
Place your scale on a firm, flat surface near your computer.
Connect your scale to your computer using the USB cable
supplied. Then press the Zero button.
Note: To connect your scale without using a USB cable, refer
to Online help for battery installation.
5. Connect the power cord.
Connect the power cord and adapter to your printer
(as shown) and switch on.
6. Printer ready.
Wait for about 10 seconds until the 2 green lights
remain constant. Your printer is now ready.
7. Align the label roll.
Press the
Note: If the label does not feed correctly please refer to label
alignment instructions inside the printer top cover.
Tear off the dispensed label.
button and check that the label feeds correctly.
Hold
Mode
Zero
10
Advertisement
