Summary of Contents for Pitney Bowes SendPro Bluetooth SendKit
Page 1
A mobile device on which you have full admin rights to allow downloading and installing software, if necessary. If you have not received the email from Pitney Bowes, do not go any further with this installation. Please visit pitneybowes.com for...
1. Opening the box and unpacking. Here’s a diagram and explanation of the items you should find in your box. Printer Power Cord Label Roll (DK roll) Scale Printer control panel buttons you need to use. Feed Cutter Bluetooth Power 2.
5. Loading the label roll. 1. Pull the release levers on the both sides of the printer to unlock the cover, and lift the cover to open it. Remove the protective sheet from the output slot. 2. Place the label roll into the guide. Make sure the roll is inserted firmly in the guide and the stabilizer slides into the notch in the printer 3.
6. Connecting the scale to the printer. Connect the USB wire from the scale to the printer, as shown. 7. Pairing the printer by Bluetooth. Press and hold the Bluetooth button to pair printer with your mobile device. 8. Setup the printer. 1.
Page 5
3. Select Bluetooth Printer and select Roll - 4x6 for Label print size. 4. Tap on Print Sample for test print. 5. Select QL-1110NWB printer to print a sample label.
2. If the error is not reset, press the Cutter Button. 3. If the error is not reset, turn off the Printer, and then turn it on again. 4. If the error is not reset, contact Pitney Bowes Customer Service.