Specifications; Parameters; Functions - Acom 1010 User Manual

6. SPECIFICATIONS

6.1. Parameters

a) Frequency Coverage: All amateur bands in the 1.8-29.7MHz frequency range. Extensions
and/or changes on request;
b) Power Output: 700W PEP or 500W continuous carrier;
c) Intermodulation Distortion: Better than 35dB below rated output;
d) Hum and noise: Better than 40dB below rated output;
e) Harmonic Output Suppression: Better than 50dB below rated output;
f) Input and Output Impedance:
Nominal value: 50 Ohm unbalanced, UHF (SO-239) type connectors;
•
Input circuit: broadband, VSWR less than 1.3:1, 1.8-30MHz continuously (no tuning, no
•
switching);
Bypass path: VSWR less than 1.1:1, 1.8-30MHz continuously, 200W maximum;
•
Output (antenna) impedance matching capability: VSWR up to 3:1 or higher;
•
g) RF Gain: 11dB typically, frequency response less than 1dB (50 to 70W drive power for rated
output);
h) Primary Power: 85-132V/170-264VAC (100, 110, 120, 200, 210, 220, 230 & 240V nominal
taps), +10% -15% tolerance), 50-60Hz, single phase, 1200VA;
i) Complies with CE safety and electromagnetic compatibility requirements as well as FCC-
regulations (10 & 12m band locks provided);
j) Size & Weight (operating): WxDxH: 402x315x166mm, 16kg (15.83x12.4x6.5 inches, 35.3lbs.);
k) Operating environments:
Temperature range: 0 to +50 degrees Celsius;
•
Humidity: up to 95% @ +35 degrees Celsius;
•
Height: up to 3000m above sea level without output deterioration.
•

6.2. Functions

a) Antenna Impedance Matching Process: aided by a plate-load True Resistance Indicator (TRI);
b) Two antenna outputs selectable by a button on the front panel;
Page 28 of 32 | S e c t i o n SPECIFICATIONS
User's Manual | ACOM 1010 | HF Linear Amplifier
August 2020