Specifications; Parameters - Acom 1010 User Manual

User's Manual | ACOM 1010 | HF Linear Amplifier

6. SPECIFICATIONS

6.1. Parameters

a) Frequency Coverage
All amateur bands in the 1.8-29.7 MHz frequency range;
•
Extensions and/or changes on request;
•
b) Power Output
700 W PEP or 500 W continuous carrier;
•
c) Intermodulation Distortion
Better than 35 dB below rated output;
•
d) Hum and Noise
Better than 40 dB below rated output;
•
e) Harmonic Output Suppression
Better than 50 dB below rated output;
•
f) Input and Output Impedance
Nominal value: 50 Ohm unbalanced, UHF (SO-239) type connectors;
•
Input circuit: broadband, SWR less than 1.3:1, 1.8-30 MHz continuously (no tuning, no
•
switching);
Bypass path: SWR less than 1.1:1, 1.8-30 MHz continuously, 200 W maximum;
•
Output (antenna) impedance matching capability: SWR up to 3:1 or higher;
•
g) RF Gain
11 dB typically, frequency response less than 1 dB (50-70 W drive power for rated
•
output);
h) Mains Power Supply Voltage
85-132 VAC / 170-264 VAC (100, 110, 120, 200, 210, 220, 230 & 240 V nominal taps,
•
+10% -15% tolerance), 50-60 Hz, Single phase;
i) Mains Power Consumption
1200 VA at rated output;
•
j) Safety and Electromagnetic Compatibility
Complies with CE safety and electromagnetic compatibility requirements, as well as with
•
the US Federal Communications Commission (FCC) regulations;
k) Size & Weight (operating, excluding connected cables)
WxDxH: 402x315x166 mm, 17 kg (15.9x12.4x6.6 inches, 37.5 lbs.);
•
July 2021 S e c t i o n SPECIFICATIONS | Page 33 of 40