Installation; Unpacking And Initial Inspection; Line Voltage Selection; Table 2-1 Acom 1010 Individual Data - Acom 1010 User Manual

User's Manual | ACOM 1010 | HF Linear Amplifier

2. INSTALLATION

2.1. Unpacking and Initial Inspection

Забележка!
Note!
Before you install your amplifier, thoroughly read this manual. First, carefully inspect the
cardboard carton and its contents for physical damage. ACOM ships amplifiers in highly
protected containers, but it cannot assure that mistreatment by shippers will not occur.
If damage is evident, notify your dealer immediately. Delay may void the carrier's
warranty.
Keep all packing materials for possible future amplifier shipment.

2.2. Line Voltage Selection

To avoid damage, which will not be covered under your warranty, check carefully to be
certain that the voltage for which the amplifier is set corresponds to your mains nominal
voltage.
Normally, the amplifier is supplied set for a nominal line voltage of 240V. If your mains voltage is not 240V,
you must contact your dealer for instructions. The only exception to this is if the unit has been custom
ordered, in which case the voltage selection will be noted in the Table of Individual Data (see
ACOM 1010 Individual Data
August 2020
N O T E
W A R N I N G
).
Voltage Selector Position

Table 2-1 ACOM 1010 Individual Data

AMP SN:
Tube SN:
VAC
S e c t i o n INSTALLATION | Page 11 of 32
Table 2-1