Advertisement
2
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To configure the supply:
1.
Position the power supply module so that the jumpers and pins are
facing upward as shown in figure 1.
2.
Set the jumpers as shown in table A. Use needle nose pliers to set the
jumpers.
WARNING: Turn off all power-supply modules before
removing modules from or inserting modules into a chassis.
Failure to observe this warning could alter processor memory,
damage module circuitry, and cause unintended operation which
could possibly cause injury to personnel.
Advertisement
