Table of Contents
Advertisement
LED Indicators
A
Power
B
LAN
C
ISDN
All 7 LEDs will light briefly on power on. This is normal.
Rear Panel Connectors & Switches
1
Power port
2
10/100BaseT
ports
3
DIP switches
4
ISDN port
Lights when power is ON.
LNK –ON when a LAN connection is established. Flash
while data traffic is on the LAN.
ERR –Indicates an error, but normally lights up briefly
during power On.
LAN –ON when a LAN connection is established.
B1 –ON when a B1 channel is established. Flash while the
B1 channel is in use.
B2 –ON when a B2 channel is established. Flash while the
B2 channel is in use.
LK –ON while the ISDN control signal is established.
Connect the power adapter here. Use only the unit
provided. (12VDC, 1Amp)
Connect 10/100 BaseT cabling here, and the other
end to the PC.
See the following section.
Use a cable with RJ45 connectors to link this port
to the S/T interface on the NT-1.
About Internet Router
5
Advertisement
Table of Contents
