Asus ISDNLink INET-800 User Manual page 23

nd
SPDI (2 B Channel)
LAN Settings
We recommend that you use the DHCP server function in the Internet Router.
Ø If you wish to use the built-in DHCP server:
No changes are required. However, all devices on your LAN must either be a
DHCP Client OR use a compatible IP Address and Network mask.
Ø If your LAN already has a DHCP server:
•
Set DIP switch 2 ON to disable the DHCP server in the Internet Router
•
Give the Internet Router an IP address compatible with the addresses allo-
cated by the DHCP server. (i.e. the last 3-digit number is NOT within the
addresses allocated by the DHCP server; the other numbers are the same as
the addresses allocated by the DHCP server.)
•
The Network Mask must be the same as the value used by the DHCP server.
Ø If you wish to use static (fixed) IP Addresses:
•
Give the Internet Router an IP Address within the same address range as
PCs on your LAN. (Only the last 3-digit number should be different for
each device.)
•
The IP Sharer's Network Mask must be the same value as PCs on your
LAN.
If you want to change the Internet Router IP address,
please read following statements carefully.
Where 555-555-1234 is the phone
number, and 0101 is the device ID.
However, there is wide variation in SPID formats,
and you must use the method advised by your phone
company.
If your telephone company did not provide this
information, leave this blank.
Enter the SPID for the 2
Setup: Internet Router
nd
B Channel. (See above)
15