Using Monitor Unit (V600-P01); Monitor Unit Functions - Omron V600-CA8A-V Series Operation Manual

Using Monitor Unit (V600-P01)

4-1

Using Monitor Unit (V600-P01)

4-1-1 Monitor Unit Functions

MONITOR mode
RUN mode
38
The Monitor Unit is a monitoring tool mounted on the ID Controller. It can be used
during system startup to check communications with the DC, to read or write
data to the DC, and to read any error messages.
The Monitor Unit has the following functions which are executed in the MON-
ITOR Mode.
JOB: The job
READ: Read
operation
WRITE1: Stepped
write operation
WRITE2: Continu-
ous write operation
TEST: test function
ERR: Error log
display
Note Remove the Monitor Unit before starting operations.
Sets Head no. and page no.
Reads data in any desired DC address.
Writes data into any desired DC address
one byte at a time.
Writes the same data to any desired DC
memory areas.
Read
Write
Repeats execution of communications
between the R/W Head and the DC.
Auto read
Auto write
Error message
Reads out new information in stored error
display
data sequentially.
Clear error
Clears error data stored in ID Controller.
Display error
Displays subtotals of number of errors by
statistics
type.
Clear error
Clears error statistics.
statistics
The date (year, month, day) to start
keeping statistics can be specified.
In the RUN Mode, Monitor Unit Key in-
put cannot be accepted.
Section 4-1