Parameter - Alesis 2 Reference Manual

Parameter

Now we will choose the desired parameters for our EQ.
¿
Press the [PARAMETER] button
The [PARAMETER] button's LED will light.
If the display reads " RIGHT OUTPUT SELECTED " you have not yet moved back to
J
BLOCK 1. Press the [< BLOCK] button to move the pointer in the display to Block 1.
The display will now show you the first of three pages:
LOW PASS: 1000Hz GAIN:
+0.0dB
These are the only two parameters on this page: Low Pass Frequency and Gain. The
cursor appears beneath the Frequency setting (in the display above it is set to
1000Hz; your display may read something different).
¡
Turn the [VALUE/ENTER] knob to select a frequency between 200 and
10000Hz.
¬
Press the [PAGE >] button to move the cursor to the Gain parameter.
÷
Turn the [VALUE/ENTER] knob to set the Low Pass gain from -14 to +14 dB.
Set the Gain below 0dB to "cut" or above 0dB to "boost" the selected
Frequency; a setting of 0dB has no effect.
ƒ
Press the [PAGE >] button to advance to Parameter Page 2 of this EQ Block.
The display will look like this:
MID BAND: 1000Hz +0.0dB
1.00OCT
This page has three parameters: Mid Band Frequency, Gain and Q (or bandwidth).
ª
Turn the [VALUE/ENTER] knob to select a frequency from 200 to 10000Hz.
D
Press the [PAGE >] button to move the cursor to the Gain parameter.
«
Turn the [VALUE/ENTER] knob to set the Mid Band gain from -14 to +14 dB.
Set the Gain below 0dB to "cut" or above 0dB to "boost" the selected
Frequency; a setting of 0dB has no effect.
»
Press the [PAGE >] button to move the cursor to the Q parameter.
...
Turn the [VALUE/ENTER] knob to set the Mid Band EQ's bandwidth from .20 to
2.50 octave.
Set the Q to a small number to effect the specific frequency you selected, or to a
larger number to affect a wider range of frequencies centered around the
selected frequency.
Continue editing the remaining EQ parameters in a similar manner.
QuadraVerb 2 Reference Manual
Making Your Own Patches - Chapter 4
49