Alesis 2 Reference Manual page 64

SAMPLE CLOCK
SOURCE:INTERNAL
Page 6: Dig In/Out Channels. When using the Alesis Optical DIGITAL [IN]
connector, (Input Audio Source must be set to "OPTICAL DATA", see above), this
page allows you to select which of the 8 channels on the optical buss will be routed to
the L and R IN. Both inputs can be set to receive any channel on the buss, from 1 to
8. You can even route the same channel to both inputs. Since the QuadraVerb 2 has
two outputs (left and right), you get to chose which of the 8 channels on the outgoing
optical buss they should be sent on. Both outputs can be routed to any channel on
the buss, from 1 to 8. However, you cannot assign both outputs to the same channel
on the optical buss. For the outputs to be routed at all, the Digital Output Mode must
be set to "NORMAL" (see below).
DIG CH IN: L=1,R=2 OUT: L=1,R=2
Page 7: Digital Output Mode. This determines how the DIGITAL [OUT]
connector will function. When set to "NORMAL", the QuadraVerb 2's LR OUT is
routed to the DIGITAL [OUT] connector. When set to "THRU", whatever is received at
the DIGITAL [IN] connector is passed on to the DIGITAL [OUT] connector without any
processing occurring on the digital signal within the QuadraVerb 2. Use this mode
when you are connected between to Alesis Optical devices (such as ADAT) between
which you wish to bounce digital audio.
DIGITAL OUTPUT MODE: NORMAL
QuadraVerb 2 Reference Manual
Description of Controls - Chapter 5
63