Alesis 2 Quick Setup

QUICK SETUP

Connect your source (instrument, mic, mixer) to either of
n
MIDIVERB II's inputs; both inputs if you have a stereo signal.
Connect the MIDIVERB II outputs to your instrument amp(s)
n
or stereo mixer returns.
n
Set the MIX control to 50/50
Start the source signal.
n
Turn the INPUT control clockwise until the green SIGNAL
n
LED stays on (when signal is present) and the red OVLD
(overload) LED flashes occasionally on peaks.
Turn the OUTPUT control clockwise to the volume level you desire.
n
Change Programs manually by pressing any two numbered
n
buttons 00-99
Set the MIDI receive channel: Press CHAN followed by two
n
numbered buttons 01-l 6.
Assign Programs to MIDI Patch numbers:
n
Press PATCH followed by two numbered buttons 01-32.
Press PRGM followed by two numbered buttons 00-99
Hold STORE and press PATCH.
The system always reverts to Program mode (PRGM LED on).
n