Installing Your Communications Software; Testing Your Faxmodem - Zoom PCMCIA V.90 User Manual

If you need to change your country setting, follow these
steps:
1
Click Start | Programs. Select World Traveler to
launch the application.
2
A dialog box will display. Select the country of your
choice from the drop-down list and click Set.
That's it! If you have problems with your faxmodem after
running the software, be sure your modem is connected
properly and try again.

Installing Your Communications Software

Please refer to your software installation guide for setting
up your communications software. You may also want to
read Chapter 2: Using Your Faxmodem for additional
fax and data configuration tips.
Then continue with the rest of this section for procedures
to test your faxmodem and remove it from your computer.

Testing Your Faxmodem

After you install and configure your fax and communica-
tions software (and your card management software if
needed), you can test whether the modem is properly
connected.
If you have installed data communications software, start
up the software. As part of its startup routine, it may
send the command AT to the modem and receive the re-
sponse OK. This indicates that your faxmodem is work-
ing.
If you do not see an AT command and response, change
to terminal mode (also known as command, direct, or lo-
cal mode). Type AT and press the Enter key. The modem
should display the word OK on your screen. If you do not
see this response, make sure that the data software is
configured for the same COM port specified in the card
management software. Then enter the AT command
again. If the modem still does not respond, refer to
Chapter 1: Setting Up Your Faxmodem 11