Dial Troubleshooting; No Response Appears After Executing A Com- Mand; The Speaker Volume Is Too High Or Too Low; The Modem Does Not Automatically Dial A Call When You Send A Dial Command Line - Zoom PCMCIA V.90 User Manual

56k pc card faxmodem with 14,400 send/receive fax

Hide thumbs

Table of Contents

answer in your software. If your software does

not have an auto-answer option, you can set

auto-answer in terminal mode. Run the Win-

dows HyperTerminal program, type AT S0=n

and press the Enter key, where n is the num-

ber of rings that you want to occur before the

modem auto-answers calls.

Problem: Your modem goes off-hook and seizes the

telephone line when the phone rings.

Solution: The modem is configured for auto-answer.

Turn off (cancel) this option in your software. If

you are using terminal mode, type AT S0=0

and press the Enter key to turn off auto-

answering.

Problem: No response appears after executing an AT

command.

Solution: If you typed a command but did not receive an

OK response from your modem:

The E0 and Q1 commands may be in effect,

disabling echo and responses. To verify this in

terminal mode, type AT &V and press Enter.

To enable echo and responses in terminal

mode, type AT E1 Q0 and press Enter.

Problem: The speaker volume is too low or too high.

Solution: You can use the speaker control settings in

Windows and in some applications software to

turn the computer's speaker on or off, or to in-

crease or reduce the speaker volume. Note

that the PC Card standard digital signaling

from the modem to the computer speaker pro-

duces inherently low fidelity sound.