Morso S11 Series Installation Manual page 6

Installation of flue collar Morsø S11 series
Contents: 1 flue collar (1).
Top flue exit
From the factory, the stove is prepared for installation with a top flue exit. The flue collar (1)
is attached to the stove with the included screws (2) and the ball stop (3).
The ball stop (3), which prevents that the chimney sweep damages the baffle plates while
sweeping, is the 160 mm long bar.
Ball stop (3), and screws (2) is encolsed in the stove.
The round disk (5) and the plate clamps (4) are not used for top flue exit installation.
Note: The paper in which the round disk is wrapped must not be disposed of by burning.
• •
• •
• •
6