Huawei SUN2000-3KTL-M1 User Manual page 48

SUN2000-(3KTL-10KTL)-M1
User Manual
Ensure that the following conditions are met. Otherwise, the SUN2000 may be
damaged, or even fire could happen.
● PV modules connected in series in each PV string are of the same specifications.
● The open-circuit voltage of each PV string must always be 1100 V DC or lower.
● The maximum short-circuit current of each PV string must always be 15 A or
● The polarities of electric connections are correct on the DC input side. The
● If polarity of the DC input power cable is reversed, do not turn off the DC
● Since the output of the PV string connected to the SUN2000 cannot be
● During the installation of PV strings and the SUN2000, the positive or negative
Terminal Description
Figure 5-11 Terminal
(1) DC input terminal
Issue 02 (2020-11-20)
WARNING
lower.
positive and negative terminals of a PV string connect to corresponding positive
and negative DC input terminals of the SUN2000.
switch immediately or remove positive and negative connectors. Wait until the
solar irradiance declines at night and the PV string current reduces to below 0.5
A, and then turn off the DC switch and remove the positive and negative
connectors. Correct the PV string polarity before reconnecting the PV string to
the SUN2000.
NO TICE
grounded, ensure that the PV module output is well insulated to ground.
terminals of PV strings may be short-circuited to ground if the power cable is
not properly installed or routed. In this case, an AC or DC short circuit may
occur and damage the SUN2000. The caused device damage is not covered
under any warranty.
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connections
(2) Battery terminal
41