Measuring Functions - Bosch GLM400CL Operating/Safety Instructions Manual

Note: Integrated Help Function
Help in the form of an animation is stored in the measuring tool
for each measuring function. To do so, select button 13 [Func],
buttons 4 [+] or 11 [–] and then soft key 3 [
The animation shows you the detailed procedure for the selected
measuring function. The animation can be stopped and started
again at any time. You can scroll forward and back with buttons
4 [+] or 11 [–].
Length Measurement
Select the length measurement
To switch on the laser beam, briefly press the measuring button
2 [ ].
09.06.2017
13:20:23
Continuous Measurement (Tracking)
For continuous measurements, the measuring tool can be moved
relative to the target, whereby the measuring value is updated
approx. every 0.5 seconds. In this manner, as an example, you
can move a certain distance away from a wall, while the actual
distance can always be read.
Select the continuous measurement
To switch on the laser beam, briefly press the measuring button
2 [ ].
Move the measuring tool until the required distance value is
indicated in the bottom of the display.
09.06.2017
13:20:23
Continuous measurement automatically switches off after 5 mins.
1.800.561.8187

Measuring Functions

To measure, briefly press the measuring button 2 [ ].
The measured value will be shown at the bottom of
the display.
0.0º
30´05˝ 6
45´08˝
Repeat the above-mentioned steps for each
60´10˝⅝
subsequent measurement. The last measured value
76´01˝5⁄ 1 6
is at the bottom of the display, the penultimate
measured value is above it, and so on.
the continuous measurement. The current measured
0.0º
30´05˝ 6
value will be shown at the bottom of the display. The
min
76´01˝5⁄ 1 6
max
maximum and minimum measured value appear
76´01˝5⁄ 1 6
above it. Pressing the measuring button 2 [ ] once
more restarts the continuous measurement.
www.
].
.
.
2 [ ] interrupts
information@itm.com
.com
29