Maintenance And Service - Bosch GLM400CL Operating/Safety Instructions Manual

error, have the measuring tool checked by an after-sales
Do not immerse the measuring tool into water or other fluids.
Wipe off debris using a moist and soft cloth. Do not use any
cleaning agents or solvents.
Take extra special care when cleaning the reception lens 20,
the laser beam exit opening 19 and the camera 18:
Ensure that there is no lint on the reception lens, the laser
beam exit opening and the digital viewfinder. Clean the
reception lens, the laser beam exit opening and the viewfinder
only with cleaning agents which are also suitable for camera
lenses. Do not attempt to remove dirt from the reception lens,
the laser beam exit opening and the viewfinder using pointed
objects, and do not wipe over the reception lens, the laser
beam exit opening and the viewfinder (risk of scratching).
If the measuring tool should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an authorized after-sales service center for
Bosch power tools. Do not open the measuring tool yourself.
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the measuring tool.
ENVIRONMENT PROTECTION
the latest regulations.
1.800.561.8187
The measuring tool monitors the correct function
for each measurement. When a defect is
determined, only the symbol shown aside flashes
in the display. In this case, or when the above
mentioned corrective measures cannot correct an

Maintenance and Service

Keep the measuring tool clean at all
times.
Recycle raw materials and batteries instead of
disposing of waste.
packaging and used batteries should be sorted for
environmentally friendly recycling in accordance with
www.
The unit, accessories,
information@itm.com
.com
43