Approved Applications; Restricted Applications - Falltech 7262 Instructions Manual

(see section 2.3 and 2.4 of this manual for clarification of these terms). This product
should be attached to your anchorage connector using a properly dimensioned
connector (such as the included carabiner).
Your anchorage should be overhead, or rigged in a manner such that Free‐Fall is
restricted to no more than 2' (2 feet). This product is not designed to be used in
applications where Free‐Fall may exceed 2'. Be sure to review the Clear‐Fall diagram
and worksheet in section 2.9 of this manual.
This product meets the requirements of OSHA 1926.502 as well as ANSI Z359.1‐2007
and ANSI A10.32‐2004. For further details on these requirements, please go to
www.osha.gov to review the OSHA requirements. Copies of the ANSI standards are
available at www.asse.org in the e‐standards store.
3.2: Approved Applications
Below are applications for which the FallTech Web SRL is specifically suited. This list
is not all‐inclusive, but is intended to anticipate the most common applications in which
this product may be used. If you have questions about whether this product is suitable
for your particular application, please consult a competent person or contact FallTech
for further advice.
Be sure to consult Section 5 of this instruction manual for details on anchorage
considerations, as the anchorage and its relationship to the walking/working surface will
be an important factor in determining suitability and could contribute to the outcome of
a fall event. Use of an anchor point that is not properly rated could lead to a
catastrophic failure of your personal fall arrest system, which may result in serious
injury or death.
Direct Overhead Applications: This product is suitable for use in any application where
the properly rated anchorage is directly above the walking/working surface, and allows
for a maximum Free‐Fall Distance of 2 feet.
Horizontal Lifelines: This product is suitable for use in any application where a
horizontal lifeline has been installed under the guidance of a qualified person, and
where the Free‐Fall Distance does not exceed 2 feet.
Residential Construction: This product is suitable for use in residential construction
applications provided the anchorage meets the basic requirements outlined in Section 5
of this instruction manual.
General Construction: This product is suitable for use in general construction
applications provided the anchorage meets the basic requirements outlined in Section 5
of this instruction manual, Free‐Fall does not exceed 2 feet, and there is no exposure to
a sharp leading edge.
Climbing/Fixed Ladders: This product is suitable for use on fixed ladders or in
conjunction with fixed ladder equipment, provided that the anchorage meets the basic
requirements outlined in Section 5 of this instruction manual and provided that it is
used in conjunction with a Full Body Harness (FBH) containing a front or chest d‐ring.
Free‐Fall must not exceed 2 feet.
General Industrial Use: This product is suitable for use in general industrial applications
provided the anchorage meets the basic requirements of Section 5 of this manual and
provided that it is not exposed to sharp edges, electrical hazards or prolonged exposure
to highly corrosive environments or substances.
Industrial Lift Trucks: This product is suitable for use in industrial lift trucks and order
pickers.
If you have any questions regarding the suitability of this product for your specific
application, please consult with a competent person or contact FallTech before using.
Misuse of this product may result in serious injury or death.
3.3: Restricted Applications
Leading‐Edge Work: This product is not suitable for leading‐edge work except in the
case of residential roofing applications.
10