Effect Mix - Alesis QS6.1 Reference Manual

[120] — E
FFECT
Not to be confused with an actual Mix or Mix mode, the EffectÕs Mix function is
where you can mix the various signal levels of all the effects to the Main Left and
Right outputs of the QS6.1. Each Effect send has a separate Mix page for any effect
module that feeds the main outputs. If an Effect send has no effect modules due to
the Configuration, or if a particular Effect module isnÕt available on that Send, youÕll
see the message NOT IN CONFIG.
Note that the Mix page doesnÕt control how much the individual effect modules feed
to each other; only how much they feed to the Main outputs.
This is what youÕll see on page 1 of the Mix function for Send 1 in Configurations 1
and 4. Depending on the selected Configuration and Send, you may see something
different on page 1. This is because the order and availability of the effects differs
from one Configuration to the next. For example: for Send 1 in Configuration #1, the
order reads Pitch, Delay, Reverb; but in Configuration #2, the order of effects for
Send 1 is Delay, Pitch, Reverb.
PITCH LEVEL
Range of Settings: 00 to 99
Adjusting this value will cause the Pitch Output Level for that Send to increase or
decrease. Even if this parameter is set to 00, the output of the Pitch section can still
feed other Effect modules (depending on the Configuration).
DELAY LEVEL
Range of Settings: 00 to 99
Adjusting this value will cause the Delay Output Level for that Send to increase or
decrease. Even if this parameter is set to 00, the output of the Delay section can still
feed other Effect modules (depending on the Configuration).
QS6.1 Reference Manual
M
IX
Part 6: Editing Effects
Page 1 Config. 1 and 4
Page 2 Config. 2 and 5
Page 2 Config. 1, 3, 4
Page 1 Config. 2
Page 3 Config. 5
95